ATMEL AVR USBasp Programmer - China
مرجع داخلي:
PROG.AVR.SERIAL
Features:
- Allows you to read or write the microcontroller EEPROM, firmware, fuse bits and lock bits
- Support for Windows, Mac OS X and Linux
- 5 KB/sec maximum write speed
- Software controlled SCK option to support targets with low clock speed (< 1.5MHz)
- 10 pin ISP interface (conforms to standard ISP 10-pin pinout)
The latest Window Drivers are fully signed, so you can use them on Windows Vista and above without any issues. The driver will work on both 32 and 64 bit platforms. On Linux And Mac OS X no kernel driver is required, just use AVRdude and specify the correct port. The programmer will work with a wide variety of Atmel AVR microcontrollers including the Atmega8a and Atmega168a. A full list is available on the specifications tab. The programmer will also work with a variety of software including
- AVRdude – Version 5.2 or later. AVRdude is available for many platforms.
- Khazama AVR Programmer – An AVRdude GUI for MS Windows
- BASCOM-AVR – Version 1.11.9.6 or later
- eXtreme Burner – An easy to use GUI application for MS Windows.
Included with the programmer is a 10 pin ISP cable, as shown in the main photo.
Pin Assignments
| Pin | Signal | Description |
| 1 | MOSI | Master Out Slave In (Data to Target Microcontroller) |
| 2 | VCC | Power Output (+5V / +3.3V supply to target board) |
| 3 | NC / RXD | Not Connected (or UART RXD on non-standard firmware) |
| 4 | GND | Ground |
| 5 | RST | Reset Signal (Connected to target Microcontroller RESET pin) |
| 6 | GND | Ground |
| 7 | SCK | Serial Clock Input to Target |
| 8 | GND | Ground |
| 9 | MISO | Master In Slave Out (Data from Target Microcontroller) |
| 10 | GND | Ground |
Your Dynamic Snippet will be displayed here...
This message is displayed because youy did not provide both a filter and a template to use.