These chrome-plated metal buttons are rugged and waterproof and look really good while doing it! Simply drill a 22mm hole into any material up to 1/2″ thick and you can fit these in place, there’s even a rubber gasket to keep any water out of the enclosure.
On the front of the button is a flat metal actuator, surrounded by a power symbol Red plastic LED ring. On the back, there are 3 contacts for the button (common, normally open, and normally closed) and 2 for the LED ring (+ and -). Connect 12V to the LED to have it light up nicely, there’s a built-in resistor! If you want to use this with a higher voltage, for 24V, simply add a 470-ohm resistor in series with the LED connection to keep the LED current at around 20mA.
- Metal self-locking pushbutton switch
- Install Diameter φ22mm
- Switch rating: 4A / 220VDC
- Switch contacts: 1 NO, 1 NC
- Material: Chrome-plated brass
- Grade: IP67 IK09
- Contact resistance: < 50 mOhm
- Insulation resistance: > 1000 Mohm
- Temperature: -20 C to +55 C
- Mechanical life: > 500,000
- Electrical life: > 50,000
- Panel thickness: 1-13mm
- Operating pressure: 1.5 – 2.5 N
- Operating stroke: 2mm
- Lamp-rated voltage: 12V
Your Dynamic Snippet will be displayed here...
This message is displayed because youy did not provide both a filter and a template to use.